ARMY
TM 5-6115-612-34
NAVY
AG -320B0-MME-000
4-3.
STARTER ASSEMBLY. (cont)
d.
Test After Repair
NOTE
Additional power source that can be
used is ECU-9/M test stand.
(1)
Connect starter as shown in figure 4-5.
CAUTION
To prevent damage to the solenoid
starting switch, perform the following test
as quickly as possible.
(2)
Momentarily attach heavy gauge test
lead and jump solenoid battery (+) terminal (1) to switch
terminal (2). Voltmeter should indicate not less than
+13.5 volts. Pinion should reposition and rotate.
Disconnect test lead.
e.
Installation. Install starter in generator set
in accordance with procedures in paragraph 4-32c, TM
5-6115-612-12.
4-20 Change 4
