ARMY TM  5-6115-612-34 MARINE CORPS TM 6115-34/8 AIR  FORCE TO  35C2-3-471-2 NAVY AG-320BO-MME-OOO 5-2. GENERATOR  ASSEMBLY  MAINTENANCE. (cont) a. Installed  Test.  (cont) (6) Using a multimeter set on R1, check resistance on GECM connector (figure  5-3)  in  accordance  with  table 5-1. (7) If any reading is incorrect, replace  generator  (paragraph  2-6). (8) Connect cables to positive and negative output connectors and to GECM  connector. (9) Connect battery cable plug connector  to  battery. (10) Install engine housing access cover and secure with turnlock fasteners. b. Removed Test. WARNING To prevent injury, do not perform maintenance on hot components. Allow  adequate  time  for  cooling. (1)  Remove generator in accordance  with  paragraph  2-6a. (2) Attempt to move shaft up and down by hand. If shaft moves up and down, disassemble generator (paragraph 5-2d)  and  replace  bearings. (3) Rotate generator shaft by hand. If rotor rubs, binds, or makes unusual noise, disassemble  generator (paragraph 5-2d) and replace rotor (if damaged)  and  bearings. (4) Install generator (paragraph 2-6b). c. Removal. Remove generator in accordance  with  paragraph  2-6a. d. Disassembly. To prevent injury, do not perform maintenance on hot components. Allow  adequate  time  for  cooling. (1) Remove screws (1, figure 5-4) and washers (2). Lift upper access cover (3) off filter box. WARNING To prevent injury, ensure that capacitor is discharged to ground before  performing  maintenance. (2) Remove nut (4), lockwasher (5), washer (6), and  bolt  (7)  to disconnect  bus  bar  (8)  from  generator bus bar. (3)  Remove capscrews (9), lockwasher  (10), and washers (11) to separate  filter  box  from  generator. (4) Remove bolt (12), lockwasher (13), and washer (14) to disconnect inductor (20) from stator cable. (5) Remove nut (15) that secures inductor (20)  to negative output feedthru connector. Tag and remove wires  as  necessary. (6) Remove nuts (16), washers (17),   lockwashers (18), and capscrews (19)  to  disconnect  inductor  (20)  from left and right sides of filter box. Lift inductor out of filter box. 5-4