5-2. GENERATOR ASSEMBLY MAINTENANCE.
(cont)
d. Disassembly. (cont)
(7) Remove screws (21), washers
(22), and filter box rear access cover
(23).
(8) Tag wiring secured to screw
(27) between output connectors. Remove
nut (24), lockwasher (25), washer (26),
and screw (27).
(9) Remove nut (28) that secures
bus
bar
(8) to positive output
connector.
Tag and remove wires as
necessary.
Remove bus bar (8) from
filter box.
(10) Remove
connector (32).
lockwashers (30),
lockwire from GECM
Remove nuts (29),
and screw (31). Tag
and
disconnect
Wiring
from
GECM
connector (32).
Carefully pull GECM
connector (32) and attached wiring out
of left side of filter box.
(11) Remove spanner nuts (33),
negative
output
connector (34) and
positive output connector (35) from
left side panel (36).
(12) Tag wiring connected to
capacitor C1 (44).
Remove screws (37)
and lockwashers (38) that secure wiring
to capacitor.
(13) Remove nuts
(39),
lock-
washers (40), screws (41), and washers
(42) that secure retaining straps (43)
and capacitor C1 (44) to right side
panel (51).
Remove glass cloth tape
(45) from between retaining strap and
capacitor.
(14) Remove
nuts
(46),
lockwashers (47), screws (48), and
washers (49) that secure resistor R1
(50) to right side panel (51).
ARMY
TM 5-6115-612-34
MARINE CORPS TM 6115-34/8
AIR FORCE
TO 35C2-3-471-2
NAVY
AG-320BO-MME-OOO
(15) If no further disassembly is
required, refer to paragraph 5-2e for
repair
procedures.
procedures for the filter
step 34, paragraph 5-2f.
CAUTION
To prevent damage and
in reassembly, ensure that parts
are clearly matchmarked prior to
disassembly.
Reassembly
box begin at
to assist
(16) Matchmark
fan
cover
(3,
figure 5-5), ring shroud (11), fan end
bell
(19),
stator
housing (46),
mounting end bell (45), and mounting
flange (13).
(17) Remove capscrews (1, figure
5-5),
lockwashers (2), and fan cover
(3).
(18) Remove cotter pin (4) from
nut (5).
(19) Secure
shaft of armature
(22) to prevent turning.
NOTE
Nut (5) is torqued approximately 480
inch pounds (54.2 Nm).
(20) Remove nut (5) and washer
(6).
(21) Slide fan (7) off armature
shaft.
Woodruff key (8) need not be
removed from armature shaft unless it
is badly damaged and affects fan fit.
(22) Remove
capscrews
(9),
lockwashers (10), and ring shroud (11).
5-9
