ARMY
TM 5-6115-612-34
MARINE CORPS TM 6115-34/8
AIR FORCE
TO 35C2-3-471-2
NAVY
AG-320BO-MME-OOO
3-7. INLET AIR HOUSING. (cont)
c. Installation. (cont)
WARNING
(4) Install 20 amp current shunt
To prevent injury, ensure that
(paragraph 4-33c, TM 5-6115-612-12).
all tools and maintenance
materials have
the
(5) Carefully feed wiring through
generator
operation.
access holes from control fender to
inlet air housing.
(16) Install
access cover and
(6) Close
control
panel
and
fasteners.
secure with turnlock fasteners.
(17) Install
(7) Install EECM access cover and
access
door
secure with turnlock fasteners.
TM5-6115-612-12).
(8) Close control panel access
(18) Install
door.
(paragraph 3-2).
(19) Stow power cable on cable
(9) Install
component
mounting
support.
panel
(paragraph
4-82b,
TM 5-6115-
612-12).
Ensure that all wiring is
(20) Connect battery cable plug
properly connected.
Refer to FO-1,
connector to battery.
TM 5-6115-612-12).
(21) Run generator set to ensure
proper
operation
(paragraph 2-3,
(10) Install
air
filter
TM 5-6115-612-12).
(paragraph 3-9b).
3-8. BLEED AIR LINE.
(11) Install
air
baffle
(paragraph 4-22d, TM 5-6115-612-12).
Removal.
Remove bleed air line
in accordance with paragraph 4-19b,
(12) Install air filter muffler TM 5-6115-612-12.
housing (paragraph 4-21d, TM 5-6115-
612-12).
b. Repair.
(1) Measure
length of
damaged
(13) Install
power
cable
hose.
(paragraph 4-81b, TM 5-6115-612-12).
(2) Use fine-toothed hacksaw and
(14) Install
slave
receptacle
cut new hose (MIL-H-27267-2) to match
(paragraph 4-29c, TM 5-6115-612-12).
length of damaged hose.
been removed from
set
prior to
engine
housing
secure with turnlock
inlet air housing
(paragraph
4-16d,
cable
support
(15) Install
battery
cable
(3) If fittings on hose to be
assembly (paragraph 4-26d, TM 5-6115-
replaced are not damaged, cut off and
612-12).
use again.
3-7
