ARMY TM  5-6115-612-34 MARINE CORPS TM 6115-34/8 AIR  FORCE TO  35C2-3-471-2 NAVY AG-320BO-MME-OOO 3-4. CONTROL FENDER ASSEMBLY.  (cont) c. Installation. (cont) (14) Connect battery cable plug connector  to  battery. (5)  Install  GECM  and  plug  in (15) Run generator set to ensure electrical connectors (paragraph proper operation (paragraph 2-3, TM 5- 4-30b,  TM  5-6115-612-12). 6115-612-12). (6)  Install  control  panel and 3-5.  EXHAUST  FENDER  ASSEMBLY. connect wiring (paragraph 2-8b). Close control panel and secure with turnlock Removal. (See figure 1-2 for fasteners. location.) (7) Install hinge  on control (1) Ensure that MASTER SWITCH is fender and secure with screws, washers, in OFF position. and nuts. WARNING (8) Refer to paragraph 2-4b for procedure to install lockbolts. Secure To prevent injury, ensure that hinge bracket to control fender with battery is disconnected  before lockbolts. performing maintenance on elec- trical  components. (9) Attach hinge bracket  to control panel access door support bar (2) Disconnect battery cable plug with screws, washers, and self-locking connector  from  battery. nuts. (3) Loosen turnlock fasteners and (10) Install control panel access remove  engine  housing  access  cover. door  (paragraph  4-16a,  TM  5-6115-612 -12). (4) Loosen turnlock fasteners and remove  exhaust  plenum  access  cover. (11) Install inlet air housing access door (paragraph 4-16d, TM 5- (5) Remove exhaust duct (para- 6115-612-12). graph 9-2). (12) Stow power cable on cable (6) Remove fuel housing  access support. door  (paragraph  4-16c, TM 5-6115- 612-12). WARNING (7) Remove oil cooler housing access cover (paragraph 4-17e, TM 5- To prevent injury, ensure that 6115-612-12). all tools and maintenance mater- ials have been removed from the (8) Refer to paragraph 2-4a for generator  set  prior  to  operation. procedure to remove lockbolts. With another person supporting exhaust (13) Install engine housing ac- fender, remove  lockbolts  that  connect cess cover and secure with turnlock exhaust fender to generator set. Pull fasteners. fender  away  from  generator  set. 3-3