ARMY
TM 5-6115-612-34
MARINE CORPS TM 6115-34/8
AIR FORCE
TO 35C2-3-471-2
NAVY
AG-320BO-MME-OOO
3-4. CONTROL FENDER ASSEMBLY. (cont)
a.
Removal. (cont)
(4) Remove power cable from cable
support.
(5) Remove
inlet
air
housing
access
door
(paragraph
4-16d, TM
5-611
door
612-1
5-612-12).
(6) Remove control panel access
(paragraph 4-16a,
TM 5-6115-
2).
(7) Remove
self-locking
nuts,
washers, and screws that secure control
panel access door support bar to hinge
bracket mount.
(8) Refer to paragraph 2-4a for
procedure to remove lockbolts.
Remove
lockbolts that secure hinge bracket to
control fender.
(9) Remove
nuts,
screws,
and
washers that secure hinge to control
fender.
(15) Ensure that all wiring has
been properly tagged and disconnected.
Remove
screws
that
hold
grommet
plates.
Carefully pull wiring into
engine housing and inlet air housing.
(16) Refer to paragraph 2-4a for
procedure
to remove lockbolts.
With
another
person
supporting
control
fender,
remove lockbolts that connect
control fender to generator set.
Pull
fender away from generator set.
b.
Repair.
(1) Weld cracks and holes.
(2) Remove dents.
(3) Remove corrosion and chipped
paint.
Prime
and
repaint
affected
areas.
(4) Measure and fabricate
new
panels.
c.
Installation.
(10) Loosen
turnlock
fasteners
and open control panel.
(11) Tag and disconnect wiring.
Remove control panel (paragraph 2-8a).
(12) Tag and unplug electrical
connectors.
Remove
generator
elec-
tronic control module (GECM) (paragraph
4-30a, TM 5-6115-612-12).
(13) Loosen
turnlock
fasteners
and remove engine electronic control
module (EECM) access cover.
(14) Tag and unplug electrical
connectors.
Remove
EECM (paragraph
4-64a, TM 5-6115-612-12).
(1) Refer to paragraph 2-4b for
procedure to install lockbolts.
Place
control fender assembly in position and
secure with lockbolts.
(2) Carefully feed wiring from
engine housing and inlet air housing
into
control fender.
Secure grommet
plates to control fender with screws.
(3) Install EECM and plug in
electrical connectors (paragraph 4-64b,
TM 5-6115-612-12).
(4) Install EECM access cover and
secure with turnlock fasteners.
3-2
