ARMY TM  5-6115-612-34 MARINE  CORPS  TM  6115-34/8 AIR  FORCE TO  35C2-3-471-2 NAVY AG-320BO-MME-OOO 3-5. EXHAUST FENDER ASSEMBLY.  (cont) b. Repair. (1) Weld cracks and holes. (2)  Remove  dents. (3) Remove corrosion and chipped paint. Prime and repaint affected areas. (4)  Measure and fabricate new panels. c. Installation. (1) Refer to paragraph 2-4a for procedures to install lockbolts. Place exhaust  fender  in  position  and  secure with  lockbolts. (2) Install exhaust duct. (paragraph 9-2). (3) Install oil cooler access housing (paragraph 4-17e, TM 5-6115- 612-12). (4)  Install  fuel  housing  access door (paragraph 4-16c, TM 5-6115- 612-12). WARNING To prevent injury, ensure that all tools and maintenance materials have been removed from the generator set prior to oper- ation. (5) Install exhaust plenum access cover and secure with turnlock fas- teners. (6) Install engine housi cover  and  secure  with  turnl teners. 3-4 ng access ock  fas- (7) Connect battery cable plug connector to battery. (8) Run generator set to ensure proper operation (paragraph 2-3, TM 5- 6115-612-12). 3-6. FUEL HOUSING. Removal. (See figure 1-2 for location.) (1) Ensure that MASTER SWITCH is in OFF position. WARNING To prevent injury, ensure that battery  is disconnected before performing maintenance on elec- trical  components. (2) Loosen turnlock fasteners and remove  engine  housing  access  cover. (3) Remove power cable from cable support. (4)  Remove cable (paragraph 3-2). (5) Remove fuel housing door (paragraph 4-16c, TM 612-12). (6)  Remove electrical transfer pump (paragraph 4-37c, support access 5-6115- fuel TM 5- 6115-612-12). (7) Remove primary fuel filter (paragraph  4-38b,  TM  5-6115-612-12). (8) Remove secondary fuel filter (paragraph  4-40b,  TM  5-6115-612-12). (9)  Remove high pressure electrical fuel pump brackets  (paragraph  4-41 612-12). and mounting a, TM 5-6115-