ARMY
TM 5-6115-612-34
MARINE CORPS TM 6115-34/8
AIR FORCE
TO 35C2-3-471-2
NAVY
AG-320BO-MME-OOO
3-8.
BLEED AIR LINE. (cont)
b. Repair. (cont)
(4) Clean bore of new hose.
(6) Remove air baffle (paragraph
4-22a, TM 5-6115-612-12).
(5) Put socket in vise and screw
(7) Remove capscrews (3), nuts
hose counterclockwise into socket until
(4), and washers (5) that secure air
it bottoms.
Back off quarter turn.
filter (2) to housing.
(6) Lightly
lubricate
nipple
threads and
inside of
hose
with
petrolatum (VV-P-236).
(7) Screw nipple clockwise into
socket
and
hose.
Leave
maximum
clearance of 1/32 to 1/16 inch (0.0794
to 0.1588 cm) between hex and socket.
Installation.
Install bleed air
line in
accordance
with
paragraph
4-19c, TM 5-6115-612-12.
3-9. AIR FILTER ASSEMBLY.
CAUTION
To prevent damage to ejectors,
use care when removing air filter
from inlet air housing.
NOTE
It may be necessary to tag and
disconnect some wiring to ease
removal
of the air filter as-
sembly.
a.
Removal.
(8) Carefully pull
air
filter
forward.
Alternately
tilt and pull
WARNING
forward to ensure that ejectors (6)
have adequate clearance during removal.
To prevent injury, ensure that
battery is
disconnected before
performing maintenance on elec-
b.
Installation.
trical components.
CAUTION
(1) Disconnect battery cable plug
To prevent damage to ejectors,
connector from battery.
use
care
when
installing
air
filter in inlet air housing.
(2) Remove power cable from cable
support.
(1) Carefully guide air filter
(3) Open inlet air housing access
ejectors (6) through muffler opening in
door.
Secure in open position.
right side of inlet air housing.
(4) Loosen turnlock fasteners and
(2) Aline
air filter (2) with
remove engine housing access cover.
mounting holes and secure with cap-
screws (3),
washers (5) and nuts (4).
(5) Disconnect bleed air line (1,
Torque to 74-82 inch pounds (8.4-9.3
figure 3-1) from air filter (2).
Nm).
3-8
