TM 5-6115-612-12.
ARMY
TM 5-6115-612-34
MARINE CORPS TM 6115-34/8
AIR FORCE
TO 35C2-3-471-2
NAVY
AG-320BO-MME-OOO
3-10.
ENGINE HOUSING. (cont)
a.
Removal. (cont)
(3) Install control panel access
door (paragraph 4-16a,
TM 5-6115-
(21) Remove fuel tank (paragraph
4-39a, TM 5-6115-612-12).
(4) Install fuel tank (paragraph
(22) Remove control panel access
4-39b, TM 5-6115-612-12).
door (paragraph 4-16a,
TM 5-6115-
612-12).
(5) Install air filter (paragraph
3-9b).
(23) Provide support for control
and exhaust fenders.
(6) Install
ignition
coil
(paragraph 4-48c, TM 5-6115-612-12).
(24) Remove any identification/
instruction plates from engine housing.
(7) Install fuel/lubrication
lines in engine housing and secure with
(25) Refer to paragraph 2-4a for
loop clamps.
procedure to remove lockbolts.
Remove
lockbolts and engine housing.
(8) Pull
wiring
into
engine
housing from fuel housing, inlet air
b. Repair.
housing and control fender.
(1) Weld cracks and holes.
(9) Install wiring harness W3
(paragraph 4-79h, TM 5-6115-612-12).
(2) Remove dents.
(10) Install grommet plates and
(3) Remove corrosion and chipped
secure with screws.
Torque to 24-36
paint.
Prime and repaint
affected
inch pounds (2.7-4.1 Nm).
areas.
(11) Secure
wiring to
engine
(4) Replace damaged sound/thermal
housing with loop clamps.
insulation (paragraph 2-4d).
(12) Install
oil
cooler
(5) Refer to paragraph 2-4e and
(paragraph 7-3b).
install new turnlock fastener recep-
tacles.
(13) Install
exhaust
duct
(paragraph 9-2).
(6) Measure
and fabricate new
panels.
(14) Install engine and gearbox
with generator (paragraph 2-7b).
c. Instal lation.
(15) Connect lubrication lines,
fuel lines,
and wiring to engine and
(1) Refer to paragraph 2-4a for
generator.
procedure to
install lockbolts.
Install engine housing and secure with
(16) Install oil filler/breather
lockbolts.
(paragraph 4-50d, TM 5-6115-612-12).
(2) Install
all identification/
(17) Close
control
panel
and
instruction plates.
secure with turnlock fasteners.
3-11
