ARMY
TM 5-6115-612-34
MARINE CORPS TM 6115-34/8
AIR FORCE
TO 35C2-3-471-2
NAVY
AG-320BO-MME-OOO
2-7.
ENGINE AND GEARB0X REMOVAL AND
INSTALLATION. (cont)
b.
Installation. (cont)
(7) Remove
self-locking
nuts
(12),
washers
(13),
and
screws
(21) Connect battery cable plug
(14) that
secure
control
panel
connector to battery.
(15) to hinge (16).
2-8.
CONTROL
PANEL
REMOVAL
AND
(8) Remove control panel to work
INSTALLATION.
area.
a.
Removal.
b.
Installation.
WARNING
To prevent injury, ensure that
battery is
disconnected before
performing
maintenance
on
electrical components.
(1) Disconnect battery cable plug
connector from battery.
(2) Unlatch
and
open
control
panel access door.
(3) Loosen turnlock fasteners (1,
figure 2-4) and open control panel.
(4) Remove self-locking nut (2),
washer (3), screw (4), and remove loop
clamp
(5) from
temperature
sensing
resistor (6).
(5) Remove self-locking nut (7),
washer (8), screw (9), and loop clamp
(10) from wire bundle (11).
(6) Tag and disconnect all wiring
to control panel components.
(1) Aline control panel (15) with
mounting holes in hinge.
(2) Secure control panel to hinge
(16) with screws (14), washers (13),
and self-locking nuts (12).
(3) Remove
tags
and
connect
wiring to control panel components.
(4) Install loop clamp (10) on
wire bundle (11) with screw (9), washer
(8), and self-locking nut (7).
(5) Install loop clamp (5) on
temperature sensing resistor (6) with
screw (4), washer (3), and self-locking
nut (2).
(6) Close
control
panel
and
secure with turnlock fasteners (1).
(7) Close control panel access
door and latch securely.
(8) Connect battery cable plug
connector to battery.
2-68
