TM 55–2835–208-23
2-22 CLEAN AND INSPECT TURBINE AIR INLET HOUSING
2-22
INITIAL SETUP
Applicable Configurations:
All
Materials:
Dry-Cleaning Solvent (20)
Lint–Free Cloth (E13)
Brush (E10)
Tools:
Personnel Required:
Engine Repairman’s Tool Kit
68B Aircraft Powerplant Repairer
NSN 5180-00-323-4944
68B Powerplant Inspector
Rubber Gloves
NSN 8415-00-266-8677
Container
Eye Protection
Equipment Condition:
Off APU Task
Combustor removed (Task 2-13)
1.
2.
3
Dry cleaning solvent (E20) is
flammable and toxic. It can irri-
tate skin and cause burns. Use
only in well-ventilated area, away
from heat and open flame. Wear
gloves. In case of contact, imme-
diately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
Clean air inlet housing (1)with bristle
brush and dry-cleaning solvent (E20).
Wipe dry with lint-free cloth (E13).
Inspect threaded inserts (2) for looseness
from air inlet housing or damaged
threads. If loose, or damaged, repair
(Task 2-23).
Inspect combustor mating flange (3) for
distortion or gouges. If found, depot re-
pair is required.
4 .
GO TO NEXT PAGE
Change 4
2 - 4 7
