TM 55-2835-208-23
2-20 INSTALL COMBUSTOR SECTION (Continued)
2-20
6.
7.
8.
9.
10.
To prevent damage to seal ring
(8), do not turn combustor as-
sembly once it is installed.
Install alignment tool (T25) (10) on re-
duction drive assembly (11).
I n s t a l l a s s e m b l y u s i n g a l i g n-
ment tool (T25) as a guide.
Slide com-
bustor puller hammer (12) until combus-
tor assembly is seated.
S e c u r e h o u s i n g ( 5 ) to air inlet
housing with clamp (9) and nut (13) at
the ten o’clock position.
Torque nut (13) to 50 inch-pounds
Loosen and re-torque nut.
Tighten combustor locating bolts (14) in-
stalled in Task 2-19, in a criss-cross pat-
tern. Torque to 45 inch-pounds, and
safety-wire using lockwire (E16).
Remove combustor puller (T3), adapter
(T11) and alignment tool (T25).
11.
GO TO NEXT PAGE
Change 4 2-43
