TM 1-2840-252-23-3
8-43
REPAIR DUAL CHIP DETECTOR
8-43
INITIAL SETUP
Materials:
Applicable Configurations:
Crocus Cloth (E16)
All
Personnel Required:
Tools:
Aircraft Powerplant Repairer
Equipment Condition:
Technical Inspection Tool Kit,
Off Engine Task
Goggles
Dry, Compressed Air Source
NOTE
This repair is allowed, provided it does not cause pin to break or crack.
1. Straighten bent pin (1) of connector (2). Use long-nose pliers to gently move pin (1) until it is straight.
2. Remove corrosion from pin (1) of connector (2). Polish pin, using in and out motion over entire length of pin until
corrosion is removed. Use crocus cloth (E16).
WARNING
When using compressed air for cleaning, use approved protective equipment for eyes and face. Do not
use more than 30 psig air pressure. Do not direct air toward yourself or another person. Failure to
comply could result in injury to eyes or skin. In case of injury, get medical attention.
3. Wear goggles. Remove loosened particles, using clean, dry, compressed air.
INSPECT
FOLLOW-ON MAINTENANCE:
None
END OF TASK
8-99