TM 55-2835-209-23
Section XV INSTALL FUEL CONTROL WIRING HARNESS ASSEMBLY
5-15 INSTALL FUEL CONTROL WIRING HARNESS ASSEMBLY
INITIAL SETUP
Tools:
Materials/Parts:
Aircraft Inspection Tool Kit (T49)
Lockwire (D43)
Crows Foot Wrench 1 1/8 inch
Engine Repairman’s Tool Kit (T47)
References:
Torque Wrench 30-150 inch-pounds
Task 4-10
Personnel Required:
Equipment Conditions:
68B Aircraft Powerplant Inspector
APU on Aircraft
68B Aircraft Powerplant Repairer
NOTE
Remove protective caps from
fuel control wiring harness
assembly prior to attaching
connectors.
Prior to assembly, all compo-
nents will be visually in-
spected for damage.
1.
Place fuel control wiring harness
assembly (1) inside fuel control
lower cover.
2.
Be sure packing stays on electrical
receptacle (2).
Remove jam nut (3).
While aligning pin with pin hole,
push receptacle (2) (P289) through
fuel control lower cover.
3.
Install jam nut (3). Torque to 37
to 43 inch-pounds.
4.
Connect electrical connector (4)
(J3) to electrical receptacle (2).
5.
Connect electrical connector (5)
(P4) to fuel solenoid valve.
6.
Connect electrical connector (6)
(P9) to fuel control assembly.
7.
Lockwire electrical connectors (4,
5, 6) with lockwire (D43).
8.
Install fuel control upper cover
(Task 4-10).
FOLLOW-ON MAINTENANCE: None.
5-30
