TM 55-2835-209-23
Section XIV REMOVE FUEL CONTROL WIRING HARNESS ASSEMBLY
5-14 REMOVE FUEL CONTROL WIRING HARNESS ASSEMBLY
INITIAL SETUP
Tools:
References:
Crows Foot Wrench 1 1/8 inch
Task 4-1
Engine Repairman’s Tool Kit (T47)
Equipment Conditions:
Personnel Required:
APU on Aircraft
68B Aircraft Powerplant Repairer
Materials/Parts:
Protective Caps and Plugs
1.
2.
3.
4.
5.
6.
7.
Remove fuel control upper cover
(Task 4-1).
To prevent clogging or contam-
ination, all exposed openings
in fuel, oil, air lines and
electrical connectors will be
capped immediately.
Be sure
caps and plugs are clean.
Disconnect electrical connector (1)
(P9) from fuel control assembly.
Disconnect electrical connector (2)
(P4) from fuel solenoid valve.
Disconnect electrical connector (3)
(J3) from electrical connector (5)
(P289).
Remove jam nut (4).
Be sure packing
stays on electrical receptacle (5).
Install jam nut on fuel control wir-
ing harness assembly.
Remove fuel control wiring harness
assembly (6).
Clean fuel control wiring harness
assembly (6) using process 7, Chap-
ter 8.
FOLLOW-ON MAINTENANCE: None.
5 - 2 9
