ARMY T M    5 - 6 1 1 5 - 6 1 2 - 34 MARINE   CORPS   TM   6115-34/8 AIR   FORCE TO    35C2-3-471-2 NAVY AG-320B0-MME-000 10-2.  ENGINE ELECTRONIC CONTROL MODULE (EECM). (cont) d. EECM connector Replacement. (2)    Installation. (cont) (a) Position terminal board in (d) Remove lockwire, screws (1, EECM  and  secure  with  screws (1), figure 10-4), nuts (2), and washers (3). washers (3), and nuts (2). Torque  to 8.5-11.5  inch  pounds  (1.O-1.3  Nm). (e) Remove connector (4) and gasket (5). Discard  gasket. (b) Connect wiring to terminal board. Remove tags. (2) Installation. (c) Place bottom cover (3, figure 10-2) on EECM and secure with (a) Slip new gasket (5) over washers (2) and screws (1). Torque to threaded  end  of  connector  (4). 10-12  inch  pounds  (1.1-1.4  Nm). (b) Position connector in EECM and secure with screws (1), washers (3), and nuts (2). Torque to 6-7 inch f. Multiple Ground Terminal pounds (0.7-0.8 Nm). Install lockwire.       Replacement. (c) Figure 10-5 is provided to (1) Removal. assist  in  proper  wire disconnect reconnect. Reconnect wiring to back of (a) Place EECM so that bottom connector  and  remove  tags. cover faces up. (d) Install bottom cover (3, (b) Remove screws (1, figure figure 10-2) and secure with washers 10-2), washers (2), and bottom cover (2) and screws (1). Torque to 10-12 (3). pounds  (1.1-1.4  Nm). (c) Tag and disconnect wiring to multiple ground terminals (9, figure e. Terminal  Board  Replacement. 10-6). (1) Removal. (d) Remove screw (5), washer (6), and nut (7), shouldered washer (a) Place EECM so that bottom (8),  and  multiple  ground  terminals  (9). cover faces up. (2) Installation. (b) Remove screws (1, figure 10-2), washers (2), and bottom cover (a) Place washer (6) on screw (3). (5). Insert screw through mounting hole in EECM. (c) Tag and disconnect wiring from terminal board (4, figure 10-6). (b)  Position multiple ground terminals (9) and shouldered washer (8) (d) Remove screws (1), nuts on threaded end of screw (5). Secure (2), washers (3), and terminal board           with nut (7). Torque to 8.5-11.5 inch (4). pounds  (1.0-1.3  Nm). 10-19