ARMY
TM 5-6115-612-34
MARINE CORPS TM 6115-34/8
AIR FORCE
TO 35C2-3-471-2
NAVY
AG-320B0-MME-000
10-2.
ENGINE
ELECTRONIC
CONTROL
MODULE (EECM). (cont)
g.
Contactor Replacement.
(cont)
(j) Remove transistor Q4 (22),
terminal
lug
(23),
nut (24), and
(e) Install contactor cover in
lockwasher (25) from mounting bracket
EECM and secure with washers (2) and
(32).
screws
(1).
Torque
to 10-12 inch
pounds (1.1-1.4 Nm).
(k) Remove
diode
CR5
(26),
shouldered
washer
(27),
nut (28),
(f) Place
bottom
cover
(3,
washer (29),
terminal lug (30), and
figure 10-2) on EECM and secure with
insulated washer (31) from mounting
washers (2) and screws (1).
Torque to
bracket (32).
10-12 inch pounds (1.1-1.4 Nm).
(2) Insta llation.
h. Diode Replacement.
(a) Place
(1) Removal.
shouldered
washer
(27) on diode CR5 (26) and install in
mounting bracket (32).
(a) Place EECM so that bottom
cover faces up.
(b) Install
insulated
washer
(31),
terminal lug (30), and washer
lug (23) on
install in
with washer
to 8.5-11.5
(b) Remove screws (1, figure
(29) on threaded end of diode. Secure
10-2), washers (2), and bottom cover
with nut (28).
Torque to 24-36 inch
(3).
pounds (2.7-4.1 Nm).
(c) Tag and disconnect wiring
(c) Place terminal
to diode mounting assembly.
transistor Q4 (22) and
mounting bracket.
Secure
(d) Disconnect and remove diode
(25) and nut (24). Torque
CR3 (10, figure 10-7).
inch pounds (1.0-1.3 Nm).
(e) Disconnect
and
remove
(d) Place washer (17) on screw
resistor VR1 (11).
(16) and install in mounting bracket.
(f) Disconnect
and
remove
(e) Install shouldered washer
capacitor C1 (12).
(21),
multiple ground terminal
(20),
and shouldered washer (19) on threaded
(g) Disconnect and remove diode
end of screw (16).
Secure with nut
CR6 (13).
(18).
Torque to 8.5-11.5 inch pounds
(1.0-1.3 Nm).
(h) Remove
screws
(14) and
washers (15) that secure
mounting
(f) Install
mounting
bracket
bracket (32) in EECM.
(32) in EECM and secure with washers
(15) and screws (14). Torque to 10-12
(i) Remove screw (16), washer
inch pounds (1.1-1.4 Nm).
(17), nut (18), shouldered washer (19),
multiple ground
terminal
(20), and
(g) Install diode CR6 (13).
shouldered washer (21) from mounting
bracket (32).
(h) Install capacitor C1 (12).
10-23
