ARMY
T M 5 - 6 1 1 5 - 6 1 2 - 34
MARINE CORPS TM 6115-34/8
AIR FORCE
TO 35C2-3-471-2
NAVY
AG-320B0-MME-000
10-2.
ENGINE
ELECTRONIC
CONTROL
MODULE (EECM). (cont)
b. Circuit Card Replacement.
(cont)
(2)
Installation.
(a) Place washer (15) on screw
(i) Position
switch
circuit
(10) and washer (9) on screw (4).
card (7) on hex spacer posts (12) while
connecting jumper cable (8).
Secure
(b) Install
assembled
screws
with lockwashers (6) and screws (5).
and washers into transistor (16) and
Torque to 10-12 inch pounds (1.1-1.4
plate insulator (17).
Nm).
(c) Position
assembled
tran-
(j) Insert connector (4) into
sistor on EECM.
switch circuit card.
(d) Place
mounting pad
(8),
(k) Position bottom cover (3)
washer (7), terminal lug (6), and nut
on EECM and secure with washers (2) and
(5) on threads of screws (4).
Torque
screws
(1).
Torque
to 10-12 inch
to 8.5-11.5 inch pounds (1.0-1.3 Nm).
pounds (1.1-1.4 Nm).
(e) P1ace mounting pad (14),
washer (13),
lockwasher (12), and nut
c.
Transist or Replacement.
(11) on threads of screw (10).
Torque
to 8.5-11.5 inch pounds (1.0-1.3 Nm).
(1) Removal.
(f) Install
transistor
cover
(3) and secure with lockwashers (2) and
(a) Place EECM so that bottom
screws (1).
Torque to 6-8 inch pounds
cover faces up.
(0.7-0.9 Nm).
(b) Remove screws (1, figure
(g) Connect wires to back of
10-2), washers (2), and bottom cover
transistor and to terminal lug.
(3).
(h) Position bottom cover (3,
(c) Tag and disconnect wiring
figure 10-2) and secure with washers
from back of transistor (16, figure
(2) and screws (1).
Torque to 10-12
10-3) and from terminal lug (6).
inch pounds (1.1-1.4 Nm).
(d) Remove screws (1), lock-
washers (2), and transistor cover (3).
d. EECM Connector Replacement.
(e) Remove screw (4), nut (5),
(1) Removal.
terminal lug (6), washer (7), mounting
pad (8), and washer (9).
(a) Place EECM so that bottom
cover is up.
(f) Remove screws (10), nut
(11),
lockwasher (12), washer (13),
(b) Remove screws (1,
figure
mounting pad (14), and washer (15).
10-2), washers (2), and cover (3).
(g) Remove transistor (16) and
(c) Tag and disconnect wiring
plate insulator (17).
from back of damaged connector.
10-17
