TM 1-2840-252-23-3
8-11
INSTALL GAS PRODUCER SPEED PICKUP (Continued)
8-11
1. Install gas producer speed pickup (1) as follows:
a. Screw on locknut (2) on gas producer speed pickup (1) until locknut stops.
b. Engage threads of gas producer speed pickup (1) and housing (3).
c.
Establish proper air gap as follows:
(1) Remove three nuts (4) and cover (5) from housing (3).
NOTE
In following step (2), gear tooth must be aligned under center of speed pickup.
(2) Insert 1/4 inch wide. 0.010 inch feeler gage (6) into housing adjustment hole (7).
GO TO NEXT PAGE
8-33
