TM 1-2840-252-23-3
8-8
CLEAN GAS PRODUCER SPEED PICKUP
8-8
INITIAL SETUP
Equipment Condition:
Applicable Configurations:
Off Engine Task
All
Remove Gas Producer Speed Pickup (Task 8-7)
Tools:
General Safety Instructions:
Powerplant Mechanic's Tool Kit,
WARNING
NSN 5180-00-323-4944
Dry cleaning solvent (E19) is flammable
Goggles
and toxic. It can irritate skin and cause
Dry, Compressed Air Source
burns. Use only in well-ventilated area,
Materials:
away from heat and open flame. In case
Dry Cleaning Solvent (E19)
of contact, immediately flush skin or
Gloves (E24)
eyes with water for at least 15 minutes.
Lint-Free Cloth (E30)
Get medical attention for eyes.
Personnel Required:
Aircraft Powerplant Repairer
1. Clean gas producer speed pickup (1) as follows:
a. Wear gloves (E24) and clean gas producer speed pickup (1). Use lint-free cloth (E30) dampened with dry
cleaning solvent (E19).
b. Use dry, lint-free cloth (E30) to remove solvent.
WARNING
When using compressed air for cleaning, use approved protective equipment for eyes and face. Do not use
more than 30 psig air pressure. Do not direct air toward yourself or another person. Failure to comply could
result in injury to eyes or skin. In case of injury, get medical attention.
c. Wear goggles. Blow dry electrical connector (2) and inside surfaces (3). Use clean, dry, compressed air.
FOLLOW-ON MAINTENANCE:
Inspect Gas Producer Speed Pickup (Task 8-9).
END OF TASK
8-29
