TM 1-2840-252-23-3
8-10
REPAIR GAS PRODUCER SPEED PICKUP
8-10
INITIAL SETUP
Materials:
Applicable Configurations:
Crocus Cloth (E16)
All
Personnel Required:
Tools:
Aircraft Powerplant Repairer
Powerplant Mechanic's Tool Kit,
Aircraft Powerplant Inspector
NSN 5180-00-323-4944
Equipment Condition:
Technical Inspection Tool Kit,
Off Engine Task
NSN 5180-00-323-5114
Goggles
Dry, Compressed Air Source
NOTE
This repair is allowed provided it does not cause pins to break or crack.
1. Straighten bent pins (1) of electrical connector (2). Using long-nose pliers, gently move pins (1)
until they are straight.
2. Remove corrosion from pins (1) of electrical connector (2). Polish pins using in and out motion
over entire length of pin until corrosion is removed. Use crocus cloth (E16).
WARNING
When using compressed air for cleaning, use approved protective equipment
for eyes and face. Do not use more than 30 psig air pressure. Do not direct air
toward yourself or another person. Failure to comply could result in injury to
eyes or skin. In case of injury, get medical attention.
3. Wear goggles. Remove loosened particles from electrical connector (2), using clean, dry,
compressed air.
INSPECT
FOLLOW-ON MAINTENANCE:
None
END OF TASK
8-31
