TM 55-2835-209-23
5-10 REPLACE IGNITER PLUG LEAD (CONT)
REMOVAL
1.
Remove nut (1), bolt (2) and clamp
(3) from igniter plug lead (4).
2.
Disconnect igniter plug lead (4)
from igniter plug assembly and ig-
nition unit.
3.
To allow igniter plug lead (4) to be
pulled through front panel assembly,
remove top bolt and loosen bottom
bolt securing inboard half of fire-
wall sleeve.
4.
Remove igniter plug lead (4).
5.
Clean igniter plug lead using proc-
ess 7, Chapter 8.
INSTALLATION
NOTE
Prior to assembly, all compo-
nents will be visually in-
spected for damage.
1.
Connect igniter plug lead (4) to ig-
niter plug assembly and ignition
unit.
Torque to 33 to 37 inch-
pounds.
2.
Install top bolt and tighten bottom
bolt securing inboard half of fire-
wall sleeve.
3.
Install clamp (3) on igniter plug
lead (4).
Position wiring harness
clamp and secure both clamps to
bracket using bolt (2) and nut (1).
Torque nut to 55 to 75 inch-pounds.
4.
Lockwire iqniter plus lead (1) with
lockwire (D43).
FOLLOW-ON MAINTENANCE: None.
5-22
