TM 55-2835-209-23
Section III REPLACE MOTIONAL PICKUP TRANSDUCER
5-3 REPLACE MOTIONAL PICKUP TRANSDUCER
This task covers: a. Removal b. Installation
INITIAL SETUP
Tools:
Aircraft Inspection Tool Kit (T49)
Depth Micrometer O-6 in.
Engine Repairman’ s Tool Kit (T47)
Micrometer O-1 inch
Monopole Shim Checking Gage (T62)
Torque Wrench 30-150 inch-pounds
Personnel Required:
68B Aircraft Powerplant Inspector
68B Aircraft Powerplant Repairer
Materials/Parts:
Antiseize Compound (D8)
Bolt
Lockwire (D43)
Lubricating Oil (D16)
Packing
Protective Caps and Plugs
Shim
Washer
Equipment Conditions:
APU on Aircraft
General Safety Instructions:
Lubricating oils, DOD-L-85734,
MIL-L-23699 and MIL-L-7808,
contain materials hazardous to
health.
They produce paraly-
sis if swallowed or from pro-
longed skin contact. They may
burn if exposed to heat or
flames.
Wash hands thoroughly
after handling.
Use only with
proper ventilation.
REMOVAL
To prevent clogging or contam-
ination, all exposed openings
in fuel, oil, air lines and
electrical connectors will be
capped immediately.
Be sure
caps and plugs are clean.
1.
Disconnect electrical connector (1).
2.
Remove bolt (2) and washer (3).
3.
Remove motional pickup transducer
(4) from gearbox assembly. Remove
shim (5) and packing (6). Discard
packing and shim.
5-7
