TM 55-2835-209-23
5-1 REMOVE APU WIRING HARNESS ASSEMBLY (CONT)
To prevent clogging or contam-
ination, all exposed openings
in fuel, oil, air lines and
electrical connectors will be
capped immediately.
Be sure
caps and plugs are clean.
NOTE
To aid in assembly, all leads
should be marked prior to re-
moval.
1.
Remove nut (1), bolt (2) and clamp
(3).
2.
Remove nut (4), bolt (5) and clamps
(6, 7).
3.
Remove nut (8), bolt (9) and clamp
( 1 0 ) .
4.
Remove nuts (11, 12, 13), bolt
(13.1) and ground wire from immer-
sion thermocouple.
Remove leads
(14) from stud marked (AL) and stud
marked (CR).
Install nuts (11, 12)
back on immersion thermocouple.
5-2
Change 1
