TM 55-2835-209-23
4-4 REPLACE FUEL CONTROL LOWER COVER SEAL (CONT)
4.
5.
6.
7.
8.
9.
Apply a uniform layer of RTV (D31)
approximately 0.010 inch thick to
binding surfaces of fuel control
lower cover and seal with acid swab-
bing brush (D5).
Install seal (1) on fuel control
lower cover.
Apply a small amount of finger pres-
sure to obtain smoothing and con-
tact.
With pressure sensitive tape (D38),
tape seal to fuel control lower
cover to maintain alignment during
cure cycle.
Cure at room temperature for 72
hours.
Remove pressure sensitive tape and
trim excess RTV.
10.
Install fuel control upper cover
(Task 4-10).
FOLLOW-ON MAINTENANCE: None.
4-10
