TM 55-2835-209-23
4-4 REPLACE FUEL CONTROL LOWER COVER SEAL (CONT)
REMOVAL
1.
Remove fuel control upper cover
(Task 4-l).
2.
Remove seal (1) from fuel control
lower cover.
INSTALLATION
1.
Be sure fuel control lower cover
surface is free of any pieces of
seal or RTV.
2.
Wipe surface to be bonded with
1, 1, 1-trichloroethane (D41) and ma-
chinery towel (D20). Wipe dry.
Keep primers closed as much as
possible to prevent premature
drying.
NOTE
Thinning is not necessary.
Use primers as received.
3.
Apply thin coat of primer (D28) to
fuel control lower cover bond sur-
face.
Allow to air dry
utes to 1 hour.
Applied RTV should not
for 30 min-
sit
more than 2 to 3 minutes prior
to assembly.
A surface skin
will develop that will inter-
fere with prior bonding.
NOTE
Do not apply RTV to
than can be done in
minute interval.
more area
the 2 to 3
Prior to assembly, all compo-
nents will be visually in-
spected for damage.
E - 6 6 A - 3 3 5
4-9
