ARMY TM  5-6115-612-34 MARINE CORPS TM 6115-34/8 AIR  FORCE TO  35C2-3-471-2 NAVY AG-320BO-MME-OOO 4-2. GENERATOR ELECTRONIC CONTROL MODULE. (cont) n. Relay  (K1)  Replacem^ent. (cont) (b)  Reconnect wiring to resistor. Remove tags. (c) Plug connector (8, figure 4-2)  into  circuit  card  (7). (c) plug connector (8, figure 4-2) into circuit card (7). (d)  Place  circuit  card  into position and secure with washers (6), (d) Place circuit card into lockwashers  (5),  and  screws  (4). position  and  secure  with  washers  (6), lockwashers  (5),  and  screws  (4). (e)  Position controller base (3) on GECM housing and secure with (e)  Position controller base lockwashers  (2)  and  screws  (1). (3) on GECM housing and secure with lockwashers  (2)  and  screws  (1). (f) Install GECM in accordance with  paragraph  4-30b,  TM5-6115-612-12. (f) Install GECM in accordance with  paragraph  4-30b,  TM5-6115-612-12. Resistor (R1, R2) Replace ment. This procedure is applicable  to resistors R1   and   R2. All other Wiring Harness Repair and resistors  are  soldered. Replacement. If it becomes necessary to repair or replace internal GECM (1) Removal. wiring, refer to GECM wiring diagram (FO-11)  and  TM5-6115-612-24P. (a) Remove GECM in accordance with  paragraph  4-30a,  TM5-6115-612-12. 4-3. STARTER ASSEMBLY. Starter repair  consists  of  testing,  cleaning, (b) Remove screws (1, figure inspecting,  and  troubleshooting. 4-2), lockwashers (2), and controller base (3). (c) Remove screws (4), lockwashers (5), washers (6), and with circuit card (7). Testing and  Troubleshooting. (1) Remove starter in accordance TM  5-6115-612-12,  paragraph  4-32b. (2) Secure starter in bench vise. (d)  Carefully lift circuit card. Disconnect  connector  (8). (3) Provide test setup as shown in figure 4-5. (e) Tag and disconnect wiring from  resistor  to  be  replaced. WARNING (f) Remove screws (4, figure To prevent injury, stay clear of 4-4),  lockwashers  (5),  and  resistor  (6). pinion when power is applied to starter. (2) Installation. (4) Connect starter as shown in figure 4-5.     If     starter     motor (a) Secure resistor (6) with energizes, disconnect battery and lockwashers  (5),  and  screws  (4). replace  solenoid. 4-13