ARMY
TM 5-6115-612-34
MARINE CORPS TM 6115-34/8
AIR FORCE
TO 35C2-3-471-2
NAVY
AG-320BO-MME-OOO
4-2. GENERATOR
ELECTRONIC
CONTROL
MODULE. (cont)
Diode
Replacement.
This
(f) Plug connector (8, figure
procedure is applicable to diodes D1
4-2) into circuit card (7).
through D5.
All other diodes are
simply soldered in place.
(g) Place
circuit card
into
position and secure with washers (6),
(1) Removal.
lockwashers (5), and screws (4).
(a) Remove GECM in accordance
(h) Position
controller
base
with paragraph 4-30a, TM5-6115-612-12.
(3) on GECM housing and secure with
lockwashers (2) and screws (1).
(b) Remove screws (1, figure
4-2) lockwashers (2), and controller
(i) Install GECM in accordance
base (3).
with paragraph 4-30b, TM5-6115-612-12.
(c) Remove screws (4),
lockwashers
(5), washers (6), and circuit card (7).
n.
Relay (K1) Replacement.
(d) Carefully
lift
circuit
(1) Removal.
card.
Disconnect connector (8).
(a) Remove GECM in accordance
(e) Tag and disconnect wiring
with paragraph 4-30a, TM5-6115-612-12.
from diode (17, figure 4-3). Diode D5
is being used in this example.
(b) Remove screws (1, figure
4-2) lockwashers (2), and controller
(f) Unscrew and remove cap (13,
base (3).
figure 4-3) and nut (14).
Nut may
remain in cap.
(c) Remove
screws
(4),
lockwashers
(5),
washers
(6), and
(g) Remove lockwasher (15) and
circuit card (7).
shouldered washer (16).
(d) Carefully
lift
circuit
(h) Remove diode (17).
card.
Disconnect
wiring
harness
connector (8) from circuit card.
(2) Ins tallation.
(e) Tag and disconnect wiring
(a) Install
diode
(17) In
from relay (3, figure 4-4).
mounting hole.
(f) Remove
screws
(1),
lockwashers (2), and relay (3).
(b) Install
shouldered washer
(16) and lockwasher (15).
(2) Insta llation.
(c) Install nut (14).
Torque
to 15-18 inch pounds (1.7-2.0 Nm).
(a) Install
relay
(3)
and
secure with lockwashers (2) and screws
(d) Install cap (13).
(1).
(b) Reconnect wiring to relay.
(e) Reconnect wiring to diode.
Remove tags.
4-11
