ARMY
TM 5-6115-612-12
MARINE CORPS TM 6115-12/7
AIR FORCE
TO 35C2-3-471-1
4-32.
STARTER ASSEMBLY. (cont)
a.
Test.
Refer to figure 4-19 for
starter test point locations.
(1) Loosen turnlock fasteners and
remove engine housing access cover.
(2) Using multimeter, place posi-
tive lead on battery connector terminal
and negative
lead on starter power
return post.
Multimeter should read 24
Vdc.
If not,
check battery cable
(paragraph 4-26).
(3) Move negative lead to sole-
noid return post.
Multimeter should
read 24V.
If not,
wire from solenoid
return post to starter power return
post is damaged and should be replaced.
(4) Open control
panel
access
door.
(5) Move MASTER SWITCH to START
position.
(6) Watch yoke for forward move-
ment and listen for sound of solenoid
moving.
If no movement or sound, check
voltage between starter enable terminal
(+) and starter power return post (-).
If 24 Vdc present, replace solenoid.
(7) If yoke moves but starter
does not rotate,
check for 24V at
starter input terminal.
If 24V are
present,
starter is bad.
If no 24V
reading, solenoid is bad.
(8) Move MASTER SWITCH to OFF
position.
(9) Close control
panel
access
door.
(10) Install
engine
housing
access cover and secure- with turnlock
fasteners.
NAVY
AG-320B0-0MM-000
b. Removal.
WARNING
To prevent injury, ensure that
battery is
disconnected before
performing
maintenance
on
electrical components.
(1) Disconnect battery cable plug
connector from battery.
(2) Loosen turnlock fasteners and
remove engine housing access cover.
(3) Tag
and
disconnect
all
electrical connections to starter.
CAUTION
To
prevent damage, do not let
starter rest unsupported in gear-
box .
Severe damage to starter
shaft or gearbox could result.
(4) Support
starter.
Remove
lockwire, bolts (1, figure 4-20), and
washers (2) that secure starter (3) to
starter mounting plate (4).
(5) Carefully
pull
starter
straight out of gearbox.
c.
Installation.
CAUTION
To prevent damage, do not let
starter rest unsupported in gear-
box.
Severe damage to starter
shaft or gearbox could result.
(1) Carefully
install
starter
shaft in gearbox.
Support starter and
install
washers (2) and bolts (1).
Torque to 45-55 inch pounds (5.1-6.2
Nm).
Lockwire bolts.
4-79
