ARMY
TM 5-6115-612-12
MARINE CORPS TM 6115-12/7
AIR FORCE
TO 35C2-3-471-1
NAVY
AG-320B0-0MH-000
4-21. AIR
FILTER MUFFLER HOUSING.
(cont)
C.
Repair.
Repair of
the air
(2) Remove power cable from cable
filter muffler housing is
limited to
support.
replacing the sound controlling blanket
material on the inside of the housing.
(3) Open inlet air housing access
door.
Secure in open position.
(1) Clean surfaces of housing
with alcohol.
Ensure that all dirt and
(4) Loosen turnlock fasteners and
grease are removed.
remove engine housing access cover.
(2) Cut new piece of sound
(5) Refer to inset in figure 4-12
controlling blanket to fit area to be
and
note
location of
air baffle
covered.
attaching parts.
(3) Seal cut edges of blanket
(6) Remove screws (7) and washers
with edge sealer (ADM6SE80-PB).
(8) that
secure
air
baffle
(9).
Carefully remove air baffle from inlet
(4) Peel covering from side of
air housing.
self-stick blanket that will face metal
surface.
b.
Inspection.
Inspect air baffle
for
damage.
Ensure
that
sound
(5) Press blanket firmly into
controlling blanket (10) is securely in
place in housing.
place and undamaged.
d.
Installation.
Aline
air
c.
Repair.
Repair of
the air
filter
muffler
housing
(5)
with
baffle is limited to replacing
the
mounting holes and secure with washers
(4) and screws (3).
sound controlling blanket.
Torque to 24-36
inch pounds (2.7-4.1 Nm).
(1) Clean surface of air baffle
with alcohol.
Ensure that all dirt and
grease are removed.
4-22. AIR BAFFLE.
Maintenance of
the
air
baffle (9,
figure
4-12)
(2) cut
new
piece of
sound
consists of
inspection,
replacement,
controlling blanket to fit area to be
and repair.
covered.
a.
Removal.
(3) Seal cut edges of blanket
with edge sealer (ADM6SE80-PB).
WARNING
(4) Peel covering from side of
To prevent injury, ensure that
self-stick blanket that will face metal
battery is
disconnected before
surface.
performing maintenance.
(1) Disconnect battery cable plug
(5) Press
blanket
firmly into
connector from battery.
place on air baffle.
4-62
