4-22. AIR BAFFLE. (cont) d. Installation. (1)  Carefully  guide  air  baffle (9) into position in inlet air housing. (2) Secure with washers (8) and screws (7). (3) Torque to 36-40 inch pounds (4.1-4.6 Nm). (4) Install engine housing access cover and secure with turnlock fasteners. (5) Close inlet air housing access door. (6)  Stow  power cable  on  cable support. (7)  Connect  battery  cable  plug connector  to  battery. 4-23. ENGINE HOUSING.  The engine housing contains the gas turbine engine, the  generator,  fuel lines, bleed air line, and electrical wiring. It  provides  access  for  clean  inlet air. To ensure proper operation of the generator set, the engine housing must be  inspected  for  damage  or  foreign objects  that  could  hamper  operations. See figure 1-1  for  location  of  the engine housing. Use   the   following procedure  to  inspect  the  engine  housing. a. Loosen  turnlock  fasteners  and remove  engine  housing  access  cover. b. Check engine housing for dents, holes, sharp edges or damaged insulation. ARMY TM  5-6115-612-12 MARINE  CORPS  TM  6115-12/7 AIR  FORCE T0 35C2-3-471-1 NAVY AG-320B0-0MM-000 Check for corrosion and chipped paint. d. Check for fuel/oil leaks. e. Report any   damage   to   direct support  maintenance. f. Remove any tools, rags, or other foreign  material  from  engine  housing. g. Install  engine  housing  access cover and secure with turnlock fasteners. 4-24. ENGINE   SUPPORT engine support assembly consists  of  the  engine and  resilient  mounts. ASSEMBLY.  The (figure  4-13) mounting  frame It  provides support, thermal expansion, and vibra- tion  isolation  for  the  gas  turbine engine and gearbox. Use  the  following procedure to inspect the engine support assembly. a. Loosen  turnlock  fasteners  and remove  engine  housing  access  cover. b. Feel resilient mounts and check for cracking and  other  damage. If damaged, notify direct support maintenance. c. Check  for  cracked  welds. d. Ensure  that  all  fasteners  are tight. If the fasteners are not tight, notify  direct  support  maintenance. e. Install engine housing access cover and secure with turnlock fasteners. 4-63