4-16. ACCESS DOORS. (cont)
b.
Exhaust Door.
(2) Installation.
Attach hinge
(21) to exhaust with screws (22), and
washers (23).
Secure exhaust door (20)
to hinge
with screws (17), washers
(19). and nuts (18). Torque to 36-40
Inch-pounds (4-4.5 Nm). ‘
c.
Fuel Housing Access Door.
(1) Removal.
(a) Remove power cable
cable support assembly.
(b) Unlatch and open door
figure 4-8).
(c) Remove screws
(26), and washers (27) that
to hinge (28). Remove door.
(d) Remove screws
(30), washers (31), and door
(2) Installation.
(a) Install door
secure with screws (29),
and nuts (30).
Torque
pounds (1.3-1.5 Nm).
(b) Secure door
(28) with sc
and nuts (26
pounds (4-4.5
(c)
door.
rews (25),
T o r q u e
Nm).
(25),
secure
(29),
from
(24,
nuts
door
nuts
latch (32).
ARMY
TM 5-6115-612-12
MARINE CORPS TM 6115-12/7
AIR FORCE
TO 35C2-3-471-1
NAVY
AG-320B0-0MM-000
d.
Inlet
Air
Housing
Access
Door.
Procedure
for
removal
and
installation of the inlet air housing
access door is the same as for removal
and installation of the fuel housing
access door.
4-17.
ACCESS
COVERS. Organizational
maintenance of access covers (figure
4-10) consists of replacement.
During
replacement procedures on all access
covers,
inspect
the gasketing, in-
sulation,
and turnlock fasteners for
damage or defect.
If damage or defect
is found, refer to direct support main-
tenance.
a.
Plenum Access Cover.
(1) Removal. Loosen
turnlock
fasteners and remove
plenum access
cover (1).
(2) Installation.
(a) Ensure
that
gasket
and
insulation are securely in place and
undamaged.
(b) Aline plenum access cover
(1) with mounting holes and secure with
turnlock fasteners.
latch (32) and
washers (31),
to 12-14 inch
(24) to hinge
washers (27),
to 36-40 inch
Close and securely latch
(d) Stow power cable on cable
SuPPOrt assembly.
b.
Engine Housing Access Cover.
(1) Removal. Loosen
turnlock
fasteners
and remove
engine housing
access cover (2).
(2) Installation.
(a)
insulation
undamaged.
(b)
cover
(2)
secure with
Ensure
that
are securely
Aline engine
gasket
and
in place and
housing access
with
mounting
holes and
turnlock fasteners.
4-55
