CLEAN AND INSPECT COMBUSTOR HOUSING

CLEAN AND INSPECT COMBUSTOR HOUSING (Continued)

TM-55-2835-208-23 Transportability Guidance Small Emplacement Excavator (SEE) High Mobility Entrencher (HME) High Mobility Material Handler (HMMH) Manual
Page Navigation
72

TM 55-2835-208-23 2-15 CLEAN AND INSPECT COMBUSTOR HOUSING 2-15 INITIAL SETUP Equipment Condition: General Safety Instructions Off APU Task Disassemble combustor assembly (Task All 2-14) Tools: Engine Repairman’s Tool Kit NSN 5180-00-323-4944 Rubber Gloves NSN 8415-00-266-8677 Stainless Steel Wire Brush NSN 7920-00-269-1259 Eye Protection Materials: Methyl-Ethyl-Ketone (MEK) (E9) Personnel Required: 68B Aircraft Powerplant Repairer 68B Powerplant Inspector General Safety Instructions: When handling combustor assembly internal parts that have been exposed to fuels con- taining tetra-ethyl lead, ensure that the by product (poisonous lead oxide) is not in- haled or taken into the body through cuts or other external openings. If accidental ex- posure occurs, drench affected area with large amounts of clear water, and obtain im- mediate medical attention. Gloves and gog- gles shall be worn at all times when handling contaminated parts. MEK is flammable and toxic. It can irritate skin and cause burns. Use in well-ventilated area, away from heat and open flame. Wear gloves. In case of contact, imme- diately flush skin or eyes with water for at least 15 minutes. Get medical attention for eyes. 1. Wearing gloves and goggles, clean combus- tor housing using MEK (E9). Scrub with stainless steel wire brush. GO TO NEXT PAGE Change 4 2-31

Privacy Statement
Press Release
Contact