TM 55-2835-208-23
2-14 DISASSEMBLE COMBUSTOR ASSEMBLY
2-14
INITIAL SETUP
General Safety Instructions:
Applicable Configurations:
Tools:
Rubber
All
Engine Repairmans Tool Kit
NSN 5180-00-323-4944
Gloves
NSN 8415-00-266-8677
Eye Protection
Materials:
None
Personnel Required:
68B Aircraft Powerplant Repairer
Equipment Condition:
Off APU Task
Remove combustor section
(Task 2-13)
When handling combustor assembly internal
parts that have been exposed to fuels con-
taining tetra-ethyl lead, ensure that the by
product (poisonous lead oxide) is not in-
haled or taken into the body through cuts or
other external openings. If accidental ex-
posure occurs, drench affected area with
large amounts of clear water, and obtain im-
mediate medical attention. Gloves and gog-
gles shall be worn at all times when handling
contaminated parts.
1.
2.
3.
4.
Place combustor assembly on clean work
surface with exhaust end down.
Remove lockwire (E16) from bolts (1)
and discard.
Remove four (4) combustor locating bolts
(1) and lift combustor liner (2) out of
combustor housing (3)
Remove and discard six packings (4)
from combustor liner (2)
FOLLOW-ON MAINTENANCE:
None
END OF TASK
2-30
Change 4