TM 55284025423
95 INSTALL TORQUEMETER JUNCTION BOX (Continued)
95
NOTE
The output shaft, torquemeter head and
torquemeter junction box are supplied as a
calibrated set. If you replace the torqueme-
ter junction box, you must replace the out-
put shaft (Tasks 96 and 910) and the tor-
quemeter head assembly (Tasks 911 and
914).
1. Install packing (1) in groove (2) of flange (3).
Coat torquemeter head assembly connector
and flange area (3.1) (screened area) with sil-
icone grease (E23.1). Coat pin area (3.2) of
connector with silicone grease (E23.1).
GO TO NEXT PAGE
914 Change 7
