TM 55-2840-254-23
8-99
INITIAL SETUP
Materials:
Black Baking Enamel (E8)
Crocus Cloth (E15)
Applicable Configurations:
Solder (E49)
All
Personnel Required:
Tools:
68610 Aircraft Powerplant Repairer
Powerplant Mechanic's Tool Kit,
68F10 Aircraft Electrician
NSN 5180-00-323-4944
68B30 Aircraft Powerplant Inspector
Technical Inspection Tool Kit,
NSN 5180-00-323-5114
Soldering Iron, 15/32-Pound
Equipment Condition:
Off Engine Task
Stainless Steel Wire Brush
1. Repair loose electrical connector (1) as follows:
a. Remove all surface contamination near joint
(2). Use stainless steel wire brush.
b. Soider joint (2). Use solder (E49) and solder-
ing iron.
2. Repair electrical connector pin (3) as follows:
a. Straighten bent pin (3). Use long nose-pliers
to gently move pin (3) until it is straight.
b. Remove corrosion from pin (3). Polish pin
(3), using in and out motion over entire
length of pin until corrosion is removed. Use
crocus cloth (E15).
GO TO NEXT PAGE
