TM 55-2835-209-23
7-14 REPLACE SEAL ASSEMBLY (AVIM) (CONT)
5.
6.
7.
8.
9.
10.
Take care when installing
threaded adapter (7) over out-
put shaft threads or damage
may occur.
Assemble threaded adapter (7), jack
screw (8), jack nut (9) and support
bridge (10), then install onto studs
of generator mounting pad securing
with MS21044N6 or equivalent nuts.
Screw threaded adapter (7) into seal
assembly (6).
NOTE
When removing seal assembly
(6) from gearbox assembly it
is possible that air/oil ro-
tating seal (11) may follow
the seal assembly (6) from the
gearbox.
Turn jack screw (8) to remove seal
assembly (6) from bore of the gear-
box assembly.
Inspect air/oil rotating seal (11)
for damage.
No damage allowed.
Ensure air/oil rotating seal
(11) is installed flat against
bearing on all sides or damage
to air/oil rotating seal may
occur.
Install air/oil rotating seal (11)
onto output gearshaft with sealing
surface away from bearing (chamfer
side towards bearing).
Remove adapter kit (T6) (12) from
gearbox assembly.
7-30
Change 1
