TM 55-2835-209-23
7-1 REMOVE POWER SECTION ASSEMBLY (AVIM) (CONT)
1.
2.
3.
4.
5.
To prevent clogging or contam-
ination, all exposed openings
in fuel, oil, air lines and
electrical connectors will be
capped immediately.
Be sure
caps and plugs are clean.
NOTE
The ignition unit is equipped
with an open circuit safety
resistor which will allow
bleed off of stored electrical
charge when input power is re-
moved.
Disconnect igniter plug lead (1)
from ignition unit.
Remove nut (2). bolt (3) and clamps
(4, 5) from combustion case.
NOTE
To aid in assembly, leads
should be marked prior to re-
moval.
Remove nuts (6, 7, 8), bolt (8.1)
and ground wire from immersion ther-
mocouple.
Remove immersion thermo-
couple leads (9) from stud marked,
(AL), stud marked (CR) and ground
wire.
Install nuts (6, 7) back on immer-
sion thermocouple.
Remove nut (10), bolt (11) and clamp
(12).
7-2
Change 1
