TM 55-2835-209-23
4-16 REPLACE FUEL DRAIN TUBE ASSEMBLY (CONT)
REMOVAL
To prevent clogging or contam-
ination, all exposed openings
in fuel, oil, air lines and
electrical connectors will be
capped immediately.
Be sure
caps and plugs are clean.
1.
Place machinery towel (D20) under
fuel drain tube assembly (1) to
catch residual fuel.
2.
Remove fuel drain tube assembly (1).
3.
Clean fuel drain tube assembly (1)
using process 1, Chapter 8.
INSTALLATION
NOTE
Prior to assembly, all compo-
nents will be visually in-
spected for damage.
As all tubes and connectors
are installed/connected, all
protective caps/plugs shall be
removed.
1.
Lubricate orifice fitting with anti-
seize compound (D7).
2.
Install fuel drain tube assembly (1)
with angle down.
Torque to 104 to
116 inch-pounds.
FOLLOW-ON MAINTENANCE: None.
4-45
