TM 55-2835-209-23
4-14 INSTALL FUEL CONTROL ASSEMBLY (CONT)
1.
2.
3.
4.
5.
6.
7.
8.
NOTE
As all tubes and connectors
are installed/connected, all
protective caps/plugs shall be
removed.
Lubricate packing (1) with lubricat-
ing oil (D16) and install on fuel
control assembly (2) mount flange.
Use care when installing fuel
control assembly.
Be sure
fuel control assembly shaft
and coupler splines are
aligned.
Failure to do so
could result in damage to fuel
control assembly or shaft cou-
pling.
Install fuel control assembly (2)
and push aft to align and engage
fuel control splines with coupler.
Install coupling (3).
Align fuel control assembly with
fuel filter assembly at 9 o’clock
position.
Torque coupling (3) nut to 33 to 37
inch-pounds.
Tap coupling outer diameter with
rubber mallet.
Torque to 47 to 53
inch-pounds.
Repeat tap and torque until torque
remains at 47 to 53 inch-pounds.
Install fuel inlet tube assembly
(4). Torque to 190 to 220 inch-
pounds.
Install fuel solenoid valve to fuel
control assembly tube (5). Torque
to 100 to 120 inch-pounds.
Change 1
4-39
