TM 55-2835-208-23
2-54 SERVICE FUEL PUMP FILTER (Continued)
2-54
1.
Remove screws (1) and remove cover (2)
with packing (3), discard packing (3).
2.
Remove filter element (4)
remove and
discard packing (5).
3.
Inspect filter element (4) for foreign par-
ticles.
If metallic particles are found, re-
turn fuel pump to depot.
4. Soak filter element (4) in dry-cleaning
solvent (E20) for five minutes.
Use goggles to protect eyes and
face when using compressed air.
Do not exceed 30 psig. Do not
direct airstream towards yourself
or another person.
Failure to
comply may result in injury to per-
sonnel.
5.
Remove from solvent and dry with low
pressure compressed air at 30 psig maxi-
mum.
6.
If filter element (4) is not clean, replace.
NOTE
When installing filter element (4),
use steady even pressure to seat
filter to prevent damage to pack-
ing (5).
7.
Using Assembly Fluid No. 1 (E31), lubri-
cate packing (5) and install on filter ele-
ment (4) and install element.
8.
Using Assembly Fluid No. 1 (E31), lubri-
cate packing (3) and install on cover (2)
and install cover. Secure with screws
(l).
INSPECT
FOLLOW-ON MAINTENANCE:
None
END OF TASK
2-104
Change 4
