ARMY TM5–6115–612-12
NAVY AG-320B0-0MM-000
2-3. STARTING
THE
GENERATOR
(cont)
f.
st
arting Procedures.
(cont)
SET.
exhaust gases.
Do not exceed 5
(7) Once aircraft start is accom-
mph while moving set with engine
running.
plished,
move CONTACTOR switch to
OPEN.
Yellow CLOSED light Will go
off.
Allow generator set to run for a
2-4. SLAVE START OPERATION.
minimum of one minute and
SWITCH to OFF.
NOTE
It is not necessary to
down when moving short
to provide
continued
move MASTER
a.
General.
This procedure is
used in the event normal starting
operations for the generator set
cannot be accomplished.
A slave
start can be accomplished using a
shut set
jeep,
a truck,
another generator
distances
set, or other vehicle using a jumper
service.
connecting
cable
with
proper
Common
sense
precautions
connection for the slave receptacle.
follow
Include
ensuring
that
contactor switch is open; power
b.
Slave Start Procedure.
cable
is
disconnected
from
aircraft,
ground
cable is
(1) Remove dust cap (figure
disconnected,
and avoiding hot
2-5) from slave receptacle.
Figure 2-5.
Slave Start Connection
2-9
