ARMY
TM 5-6115-612-12
M A R I N E CORPS TM 6115-12/7
AIR FORCE
T O 3 5 C 2 - 3 - 4 7 1 - 1
NAVY
A G - 3 2 0 B 0 - 0 M M - 0 0 0
4 - 9 0 .
BRAKE CONTROL. (cont)
e.
Installation. (cont)
(3) Install washers (38) and nuts
(37).
Torque to 270-300 inch pounds
(30.5-33.9 Nm).
(4) Install
bellcrank
mounting
brackets (36) and secure with capscrews
(35),
washers (34), and nuts (33).
Torque to 74-82 inch pounds (8.4-9.3
Nm).
(5) Screw jamnuts (29) on brake
rod (31).
Screw one end of brake rod
into clevis (30) and one end into
handbrake control lever.
(6) Secure
clevis
(30)
to
bellcrank (24) with straight pin (28)
and cotter pin (27).
(7) Secure
bellcrank
mounting
bracket (36) with straight pin (26) and
cotter pin (25).
(8) Secure
bellcrank with
cotter pin (22).
(9) Screw
brake rod (20).
one end of brake
other end.
clevis
(21)
to
straight pin (23) and
jamnuts (18, 19) on
Screw clevis (12) on
rod and clevis (21) on
(10) Attach clevis
equalizing bar (12) with
(10) and cotter pin (9).
(21) to cable
straight pin
(11) Screw
jamnuts
(16)
and
clevis (15) on ends of brake cables
(17).
(12) Secure clevis (15) to cable
equalizing bar with straight pins (14)
and cotter pins (13).
4 - 1 6 4
(13) Secure
brake
cable
to
generator
set
frame with
retaining
straps (7), lockwashers (6), capscrews
(5), washers (4), and nuts (3). Torque
to 50-70 inch pounds (5.6-7.9 Nm).
(14) Secure brake cable to cable
mounting brackets
(8) with remaining
retaining
straps,
lockwashers,
capscrews, washers,
and nuts.
Torque
to 50-70 inch pounds (5.6-7.9 Nm).
(15) Secure end of brake cables
to remote control levers on brake with
straight pins (2) and cotter pins (1).
(16) Adjust
handbrake
as
necessary (paragraph 4-90b).
4 - 9 1 .
TORSION
tenance of the
(figure 4-56) is
AXLE ASSEMBLY.
Main-
torsion axle assembly
limited to inspection.
WARNING
To prevent injury, ensure that
handbrake is set and wheels are
chocked before inspecting torsion
axle.
a.
Set handbrake and chock both
wheels.
b.
Inspect
for damage and
ing
parts.
Report damage
maintenance.
c.
Remove
torsion
axle assembly
loose or missing attach-
Tighten
loose
parts.
to direct support for
grease cap and ensure
that cotter pin is securely installed
through spindle.
