ARMY
T M 5 - 6 1 1 5 - 6 1 2 - 12
M A R I N E C O R P S T M 6 1 1 5 - 1 2 /7
AIR FORCE
T O 3 5 C 2 - 3 - 4 7 1 - 1
NAVY
A G - 3 2 0 B 0 - 0 M M - 0 0 0
4 - 8 5 .
TERMINAL BOARDS. (cont)
a.
Inspection. (cont)
(10) Install
air
(paragraph 4-22).
(11) Install
engine
access cover and secure with
fasteners.
(12) Close
and
securely
inlet air housing access door.
baffle
housing
turnlock
latch
(13) Connect battery cable plug
connector.
(14) Stow power cable on cable
support.
b.
Removal.
(1) Remove
component
mounting
panel (paragraph 4-82).
(2) Tag
and
disconnect wiring
from terminal board to be replaced.
(3) Remove
screws
(1,
figure
4-53),
washers (2) and nuts (3) that
secure
terminal
board
to component
mounting panel.
c.
Repair.
The terminal boards are
not repairable.
If damaged, replace
with a new terminal board.
d.
Installation.
(1) Put
terminal
board in
position and secure with screws (1),
washers (2),
and nuts (3).
Torque on
TB1 is 12-14 inch pounds (1.3-1.5 Nm).
Torque on TB6 is 4.5-6 inch pounds
(0.5-0.6 Nm).
(2) Connect wiring to terminal
board.
Remove tags.
(3) Install
component
mounting
panel (paragraph 4-82).
4 - 8 6 .
R F F I L T E R ( F L 1 ) .
Maintenance
of the RF filter (figure
limited to replacement.
a.
Removal.
(1) Remove
component
panel (paragraph 4-82).
(2) Tag and disconnect
leads from filter terminals.
(3) Remove screws (4),
4-53) is
mounting
electrical
washers
(5),
and self-locking nuts (6) that
secure filter (7) to component mounting
panel.
b.
Installation.
(1) Place filter (7) in position
on component mounting panel and secure
with
screws
(4),
washers (5), and
self-locking nuts (6). Torque to 23-26
inch pounds (2.6-2.9 Nm).
(2) Connect electrical leads to
filter terminals with screws.
Remove
tags.
(3) Install
component
mounting
panel (paragraph 4-82).
4 - 8 7 .
CAPACITOR
( C 4 ) .
Maintenance
of capacitor C4 (10, figure 4-51) is
limited to replacement.
a.
Removal.
(1) Remove
component
mounting
panel (paragraph 4-82).
WARNING
To prevent injury, ensure that
capacitor is discharged to ground
prior to removal.
(2) Discharge capacitor to ground.
4 - 1 58
