TM 1-2840-252-23-3
9-2
CLEAN TORQUEMETER SENSOR
9-2
INITIAL SETUP
Equipment Condition:
Applicable Configurations:
Off Engine Task
All
Torquemeter Sensor Removed (Task 9-1)
Tools:
General Safety Instructions:
Powerplant Mechanic's Tool Kit,
WARNING
NSN 5180-00-323-4944
Dry cleaning solvent (E19) is flammable and toxic. It
Goggles
can irritate skin and cause burns. Use only in well-
Compressed Air Source
ventilated area, away from heat and open flame. In
Materials:
case of contact, immediately flush skin or eyes with
Dry Cleaning Solvent (E19)
water for at least 15 minutes. Get medical attention
Gloves (E24)
for eyes.
Lint-Free Cloth (E30)
Personnel Required:
Aircraft Powerplant Repairer
1. Clean torquemeter sensor (1) as follows:
a. Wear gloves (E24) and clean torquemeter sensor (1). Use lint-free cloth (E30) dampened with dry cleaning
solvent (E19).
b. Use dry, lint-free cloth (E30) to remove solvent.
WARNING
When using compressed air for cleaning, use approved protective equipment for eyes and face. Do not
use more than 30 psig air pressure. Do not direct air toward yourself or another person. Failure to
comply could result in injury to eyes or skin. In case of injury, get medical attention.
c. Wear goggles. Blow dry electrical connector (2) and inside surfaces (3). Use clean, dry compressed air.
FOLLOW-ON MAINTENANCE:
Inspect Torquemeter Sensor (Task 9-3).
END OF TASK
9-6
