TM 1-2840-252-23-3
7-4
REPAIR IGNITION COIL AND CABLE ASSEMBLY (Continued)
7-4
NOTE
In following step, use care when pulling end C.
Pull only far enough to firmly anchor end A
beneath several wraps of the lockwire.
d. Finish wrap by inserting lockwire (5) end A through
loop B. Hold A tight while pulling C to close loop.
Release A and carefully pull C until end A is
anchored beneath wrapping. Cut excess wire ends.
INSPECT
2.
Replace cracked insulator (6) as follows:
a. Remove retaining ring (7).
b. Remove insulator (6) from wire (8) and out of sleeve
(9).
c.
Insert new insulator (10) in sleeve (9) and over wire
(8).
d. Install new retaining ring (11).
GO TO NEXT PAGE
7-34
