TM 1-2840-252-23-2
6-60
INITIAL SETUP
Materials:
Crocus Cloth (E16)
Applicable Configurations:
All
Personnel Required:
Aircraft Powerplant Repairer
Tools:
Powerplant Mechanic's Tool Kit
Aircraft Powerplant Inspector
NSN 5180-00-323-4944
Equipment Condition:
Technical Inspection Tool Kit,
Off Engine Task
NSN 5180-00-323-5114
Goggles
Dry, Compressed Air Source
NOTE
This repair is allowed provided it does not cause pins
to break or crack
1. Straighten bent pins (1)of starting fuel solenoid
valve (2) Using long-nose pliers, gently move pins (1 )
until they are straight
2. Remove corrosion from pins (1of starting fuel
)
solenoid valve (2) Polish pins, using in and out motion
over entire length of pin until corrosion is removed Use
crocus cloth (E16)
WARNING
When using compressed air for cleaning, use
approved protective equipment for eyes and face.
Do not use more than30 psig air pressure. Do not
direct air toward yourself or another person.
Failure to comply could result in injury to eyes or
skin In case of injury, get medical attention.
3. Wear goggles. Remove loosened particlesrom pins
f
(1), using clean, dry, compressed air
INSPECT
FOLLOW-ON MAINTENANCE
None
END OF TASK
