TM 1-2840-252-23-2
6-25
INITIAL SETUP
Equipment Condition:
Off Engine Task
Applicable Configurations:
All
Start Fuel Nozzles Removed (Task 6-24)
Tools:
General Safety Instructions:
Powerplant Mechanic's Tool Kit,
WARNING
NSN 5180-00-323-4944
Goggles
Dry cleaning solvent (E19) is flammable
Dry, Compressed Air Source
and toxic. It can irritate skin and cause
burns. Use only in well-ventilated area,
Materials:
Dry Cleaning Solvent (El9)
away from heat and open flame .In case
Gloves (E24)
of contact, immediately flush skin or
Lint-Free Cloth (E30)
eyes with water for at least 5 minutes
1
.
Get medical attention for eyes.
Personnel Required:
Aircraft Powerplant Repairer
Wear gloves (E24). Clean start fuel nozzles (1). se
1
U
dry cleaning solvent (El9) and brush
After cleaning, remove residuewith clean, lint free
2
cloth (E30)
WARNING
When using compressed air for cleaning,
use approved protective equipment for
eyes and face. Do not use more than 0
3
psig air pressure. Do not direct air
toward yourself or another person.
Failure to comply could result in injury
to eyes or skin. In case of injury, get
medical attention.
Wear goggles. Blow out internal air passage (2)To
.
3
clean stuck ball, use clean, dry, compressed air.
FOLLOW-ON MAINTENANCE
Inspect Start Fuel Nozzles (Task 6-26)
END OF TASK
