TM 1-2840-252-23-2
6-1 REMOVE HYDROMECHANICAL ASSEMBLY (HMA) (Continued)
6-1
12. Remove lockwire and loosen bolt (15).
13. Remove three nuts (16) and three washers (17).
14. Remove one nut (18), washer (17) and bracket
(19).
NOTE
In following step, two repairers are required to lift
hydromechanical assembly clear of P4 connector harness.
15. Remove hydromechanical assembly (20and
)
gasket (21). It necessary scrape off old gasket. Use
putty knife.
NOTE
If hydromechanical assembly is removed from engine and
will not be reinstalled for a period longer than 48 hours, it
must be preserved (Ref Task 6-6).
FOLLOW-ON MAINTENANCE
None
END OF TASK
6-11
