TM 1-2840-252-23-2
5-21 REPAIR STARTER DRIVE ASSEMBLY (Continued)
5-21
e Remove seal (1) from seal retainer (5)
(1) Place sleeve bushing (Appendix E) (9) under
seal retainer (5)
(2) Use oil seal removal tool (Appendix E) (8) and
arbor press
(3) Remove seal (1)
WARNING
Lubricating oils cause paralysis If swallowed.
Prolonged contact with them may irritate the
skin. Handle only in well-ventilated areas
away from heat and flame. Drain and store
in approved metal safety containers. Avoid
prolonged or repeated contact with skin and
do not take internally. Wash contacted area
of skin thoroughly after handling. If irritation
of skin results, get medical attention Get
medical attention for eyes.
CAUTION
Seal must be dipped in lubricating oil (E35
or E36) before installation. Failure to
comply will cause damage to seal during dry
running period of initial engine starts
f Dip serviceable seal (1) in lubricating oil (E35 or
E36) Install seal (1)in seal retainer (5) Use oil seal
installation tool (Appendix E) (10) and arbor press
GO TO NEXT PAGE
5-66
